Reversible AC Rectified / 3/4"X200'" alt="Cox Hose Reels - 1125-SS "Stainless Steel" Series (SP Finish) : 115V AC 1/2 HP EXP> Reversible AC Rectified / 3/4"X200'" loading="lazy"/>
★★★★★ 5
Better than the green goo
Size: Full-size Truck, SUV (2-pack)
Recently, while I was at work, I noticed that I had at some point run over a nail with my car. Normally, you'd take your car to the tire shop and let them plug the hole for you. Well, the only problem was that the nail decided that it was going to poke my tire where the sidewall meets the tread, and most shops will refuse to plug a tire when it's punctured there. Makes sense, it's a liability issue for them, so I can't blame them. That still leaves me with the problem of having a tire with a nail in it. So, I could either replace the tire with either a new or used tire, which is expensive or I can try using a sealant to try and get as many miles out of my tire as I can.
In the past, I had tried using the green goo sealant on nail holes, and while it works to get you 15 miles down the road, that's about it. Now, while TireJect doesn't recommend using their product on punctures on the shoulder of the tire, I decided that I'd give it a try to see if it would work. And as of writing this review, it's been about 10 days since I put TireJect in my tire, and so far, it hasn't leaked any air, despite it not being meant for the shoulder. When money isn't so tight, I'll probably go ahead and replace the tire, especially since there's only about 4/32 tread depth left, but for the time being, I'll keep running it, and hopefully it keeps holding pressure properly like it has been.
Now, as for how easy it is to use, the only tools you will need that aren't provided, is an air compressor to allow you to re-inflate the tire. The kit comes with everything else you will need, including a valve core removal tool and a syringe to add the sealant to your tire. To use this product, you will first need to carefully remove the valve core with the provided tool, careful not to lose the core, since it doesn't come with a replacement core. After that, thread the hose on the syringe on to your valve stem, and then carefully add the required amount of sealant to the syringe. If you accidentally spill some, wipe it off before it dries, so that it doesn't stain anything. From there, just push the goo into the tire with the plunger, adding more to the syringe as necessary. When you're all done, re-install the valve core into the valve stem snuggly, careful not to over-tighten, and air up the tire to the recommended PSI with your compressor. After all that is done, go take a short, slow drive to distribute the sealant, and then recheck your air pressure.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 29, 2025
